- English
- Español
- Português
- русский
- Français
- 日本語
- Deutsch
- tiếng Việt
- Italiano
- Nederlands
- ภาษาไทย
- Polski
- 한국어
- Svenska
- magyar
- Malay
- বাংলা ভাষার
- Dansk
- Suomi
- हिन्दी
- Pilipino
- Türkçe
- Gaeilge
- العربية
- Indonesia
- Norsk
- تمل
- český
- ελληνικά
- український
- Javanese
- فارسی
- தமிழ்
- తెలుగు
- नेपाली
- Burmese
- български
- ລາວ
- Latine
- Қазақша
- Euskal
- Azərbaycan
- Slovenský jazyk
- Македонски
- Lietuvos
- Eesti Keel
- Română
- Slovenski
- मराठी
- Srpski језик
How to provide data for wind farms for wind tower manufacturers
2022-12-03
Similarly, if the wind speed pole is not firmly fixed, and the direction of the pole moves from the windward side or the windward side to the windward side, the position is vulnerable to the shadow effect of the tower anemometer and the reliability of the wind speed data will also change. Therefore, the installation of the wind measuring equipment must be reliable, and the sensor pole must be fixed at three points. The following is a brief introduction by the power tower manufacturer.
How can anemometers provide strong data for wind farms?
Since the altitude gradient is relatively large, it is recommended to establish three different altitudes, each of which is higher than the altitude. The horizon is open, and there are no adjacent mountains. There are no hills or prominent tree anemometers near the site. If the altitude gradient does not change greatly in the site area, the anemometer tower must be installed in the site area at the average altitude, and the terrain of the selected location is the same as above.
How can anemometers provide strong data for wind farms?
Since the altitude gradient is relatively large, it is recommended to establish three different altitudes, each of which is higher than the altitude. The horizon is open, and there are no adjacent mountains. There are no hills or prominent tree anemometers near the site. If the altitude gradient does not change greatly in the site area, the anemometer tower must be installed in the site area at the average altitude, and the terrain of the selected location is the same as above.
The wind direction indication is determined by the stable position of the wind direction pointer on the wind direction dial. Mechanical anemometer and wind vane are separated from each other, with simple structure and low price. The location of the anemometer tower shall be able to maximize the distribution of wind resources near the anemometer tower site. The manufacturer of the electric tower will make a scientific introduction for everyone. Generally, the higher the altitude is, the higher the wind speed is. It is possible to limit the range of the tower location, so the anemometer tower should reduce the method of expressing poor problems.
